Hm,

I honestly hate to bring this up but I read everything very carefully, did all I read here, several times and I cannot get the HQplayer to make a single sound through the NOS1a G3...

I did a fresh driver installation on a computer that doesn't have an XXhighend player installed(managed to do so after I switched off "signed off" in Windowds 10), then I went to Sounds and found the Phasure 1.0.4 WDM driver 4.0, disabled all enhancements. Even set it up as default once.

Then I run Control board, chose 384000 and then 352.K and hit apply. Chose 12ms for the USB buffer.

Then went to HQplayer setup and checked all the boxes as per Mani's instructions.

When I load a file by drag and drop on HQP and press play I get a window that as below the progress bar and a blue line goes from left to right and sometimes back but I never hear sound and the progress bar never moves... Did it a million times, the log files sometimes says that there is not enough space to perform the task, sometimes it says it could not push it to the FIFO.

One thing that I find weird is that when I try to add a file through HQP library it never recognizes music files.

Any other ideas I could try? That is with both up and down positions of Switch#5...

Decided to ask, Mani is probably very tired from my emails.