Assuming I hadn't done that, would I still get "repair with" W10-14393 against W10- 14393 RAM Memory OS option in boot into menu?

Hi Peter,

I selected the file D:\MyW10-14393.vhd from the drop down menu (pls look at my first image). Named it & added it to the boot into menu.

Best regards,

Arvind

Hi Ramesh,

Thank you.

That's exactly what I did but there are a few issues:
1) in the boot into menu against 14393 BASE the "repair file" does not show up. Even if I select the file from the drop down menu->apply->refresh, it becomes blank after refresh.
2) Currently my OS is 10586.0 RAM, if I now select any other OS-> apply-> reboot it only tries to boot into 14393.0 RAM. It shows error & then I have to manually select the OS to boot into. And it only boots into 10586.0 RAM, no other OS.

Best regards,

Arvind

Hi Peter,

But there is only one OS version after unzipping; Copy.vhd. Unlike other OS have .vhd version & Copy.vhd version.

Image attached.

Sorry for the large image size but no way to make the size smaller on the iPhone.

Best regards,

Arvind

Hi Peter,

I am attempting to add 14393.0 to the RAM OS disk using method 2. The file has been unzipped to drive D. But I am only finding the Copy version in the drop down menu.

I have attached an image of the Boot into.

I think I should have the OS other than the Copy version.

Am I doing something wrong?

Best regards,

Arvind

Hi Peter,

I would like to change my order to 35v3. If I'm not wrong this means that the main input ( NOS1a in my case) is not connected to an input selector & consequently neither the volume control.

Best regards,

Arvind

Hi Peter,

Aha so that must have been the issue, after removing the video card I must have plugged into the other ethernet port which had a different ip address. So my static ip address didn't work.

Live & learn.

Best regards,

Arvind

Sorry can't recall which one.

Hi Peter,

A very strange solution to this problem. I changed the ethernet connection in the Audio PC to the second port & the connection was established. Hard to believe this.

Best regards

Arvind

Hi Guys,

Since a week I have been using the Mach II 2640 as Audio PC, I'm not going to comment on the SQ since too many things have changed, so in all fairness any comment would not be fair.

Initially I didn't remove the video card but just disconnected it from the mobo. Yesterday I switched off the Audio PC & removed the video card. On switching on the Audio PC I am unable to connect to the Music Server using the std Windows RDC. I get connection error. I am using static IP address for connection.

Can anyone help with a solution?

Best regards,

Arvind

Hi Peter,

Pls amend my order to 35vIx3. Pls send me revised proforma invoice.

Best regards,

Arvind

Hi Peter,

I remember when I tried to bypass my preamp & feed the NOS signal directly into the amps, I never got any sound. Probably the current output from the NOS is too low to drive the amp with the speaker load. The B'ASS unit could be of help here, since essentially it's doing the job of the preamp, in terms of amplifying the NOS signal.

Best regards,

Arvind

Hi Peter,

Can you post a chart on the forum showing the increase in current amplification through each increased amp. Maybe this might help some of the guys who have the requisite technical knowledge (not me)to decide how many amps they may need for their set up.

Just a suggestion.

Best regards,

Arvind

Hi Peter,

What's the dimensions of the B'ASS unit? I couldn't find it in the threads.

Best regards,

Arvind

Hi Peter,

I'm for this one too, with 2640.

Best regards,

Arvind