|
Title: Installing driver for NOS1 Post by: briefremarks on August 08, 2024, 04:40:02 am All,
I just went through the process of installing the driver for the NOS1 on a new machine, and thought I'd share this just in case anyone else is doing this and has any problems. - When you run the setup file, you will get an error if you do not configure Windows to allow installation of unsigned drivers; - There is an option in XXHE to "Change" driver signing to not require signing. However this option does not seem to work; - You can temporarily disable signing of drivers in Windows by following instructions to restart with the shift key pressed, and then following the configuration setting options on the screen. These instructions are readily available online. Title: Re: Installing driver for NOS1 Post by: PeterSt on August 08, 2024, 02:01:09 pm Hi Ramesh,
XXHighEnd takes care of that adequately. See below. Regards, Peter Title: Re: Installing driver for NOS1 Post by: briefremarks on August 08, 2024, 06:08:00 pm Thank you Peter. I tried modifying through XXHE and rebooting a couple of times without success. Could be a problem on my side.
Title: Re: Installing driver for NOS1 Post by: PeterSt on August 09, 2024, 03:02:49 am (maybe) Try to interpret that Refresh button as it is intended (LOL). The ToolTip on it could help.
I don't know better than hat this robustly works. But maybe it can conflict with your own setting (which is not persistent) ? Thus, reboot so that your own setting is out of the way, and then next work with the XXHE setting. And of course do that in non-RAM mode. When that works, you can boot from RAM and it will work from there too. |