|
Title: Is PA Engaging? Post by: Scroobius on September 17, 2012, 07:57:07 pm With 09-z7-3 I have set PA to engage after 1 SFS round. I press "start" and music starts to play then after a short while *~* shows correctly. However when *~* shows it is not accompanied by a "tick" or "plop" which I would expect to hear as the DC offset is applied. OK so after *~* is shown if I then change the volume up or down then I get a "click" as the volume changes - that is what I would expect as the DC offset is applied. So is PA actually working when *~* is first shown?
Title: Re: Is PA Engaging? Post by: PeterSt on September 17, 2012, 10:39:06 pm Hi Paul,
I don't get it. So now we associatie PA with ticks or anything, and when not there it is not good ? :scratching: Sorry ! Peter Title: Re: Is PA Engaging? Post by: PeterSt on September 18, 2012, 10:03:45 am For the conveniency of you all, this is how Phase Alignment is dealt with in 0.9z-7-3 :
Upsampled material into a "DAC Needs" = 32 bits : works. Upsampled material into a "DAC Needs" = With Inverted Phase active, nothing is dealt with properly (Phase Alignment is not correct and ticks may be the result of that). Native material (so, not upsampled) : does not work. It does not engage, but de-engages just the same (ticks). 24 bit material played onto a 16 bit DAC : same as above. I just spent 30 hours on above issues and most of it is solved now. For 0.9z-7-4 all of these issues will be solved. Give it a few more days. Regards, Peter |