|
Title: Setting Q1 Post by: Leo on September 11, 2012, 10:00:12 am Hello Peter,
finally got my audio computer connected to the net and now there on XX7-3 in activated form as well! Audio bliss BUT: i can not get my Q1 slider higher than 8, after that it returns to 0 or 1. I searched for this topic in your manual and on the forum. Could not find this porblem anywhere. What could I be doing in the wrong way this time? regards, Leo Title: Re: Setting Q1 Post by: PeterSt on September 11, 2012, 10:02:18 am Hey Leo,
Those (new home brew) sliders are fairly wackey. What about clicking it to make it "active" and proceed with the arrow keys ? Peter Title: Re: Setting Q1 Post by: Leo on September 11, 2012, 10:10:02 am Well dat did help, all the way up to 9 :)
When I set q1 factor to 2, I get a warning that the combination of buffer, sfs and q1 is too high. Will check on exact computer memory, don't know exactly but it was pretty large Title: Re: Setting Q1 Post by: Leo on September 11, 2012, 10:45:07 am Ha Peter
The info: Motherboard Asus sabertooth p67, processor i7-2600k, 3,4 ghz, memory 16gb groet, Leo Title: Re: Setting Q1 Post by: Gerard on September 11, 2012, 11:03:49 am Hello Peter, finally got my audio computer connected to the net and now there on XX7-3 in activated form as well! Audio bliss BUT: i can not get my Q1 slider higher than 8, after that it returns to 0 or 1. I searched for this topic in your manual and on the forum. Could not find this porblem anywhere. What could I be doing in the wrong way this time? regards, Leo What i have nodiced that at a certain setting (rescale) The second number is not been seen. So it look like it goes up to 9 but the second number is 10 but it looks like 1. :) Title: Re: Setting Q1 Post by: PeterSt on September 11, 2012, 11:13:46 am Eh, Leo ...
Do you have problems with manipulating the sliders (like with Parkinson's desease) or do you always get a message and can't proceed for that reason ? Title: Re: Setting Q1 Post by: Leo on September 11, 2012, 11:19:19 am I think that Gerard found the answer....
thanks! |